What to do if the UV intensity is too low in my BWT Water Filtration System?
If the UV intensity is too low, remove and clean the quartz glass sleeve and sensor. Also, verify that the water quality meets the necessary requirements and install a filter if needed. If the issue persists, replace the UV lamp.
What to do if the UV system detects a problem with the UV lamp in my BWT Water Filtration System?
If the UV system has detected a problem with the UV lamp, try resetting the lamp protection circuit by unplugging the unit for 10 seconds. If the issue continues, replace the UV lamp with an identical one, using the spare part number indicated on the silver label of the UV reactor or on the maintenance parts display.
What to do if the module indicated is no longer communicating with the BWT Water Filtration System?
If a module is no longer communicating with the system, make sure all modules are properly plugged in and that the UV system recognizes the correct connection. You can test the modules individually by plugging them in one after the other and rebooting the UV system. Replace any module that isn't detected when plugged directly into the controller.
What to do if a missing or incorrect lamp key was detected in my BWT Water Filtration System?
If a missing or incorrect lamp key is detected, ensure that the supplied lamp key is installed and that the old key is unplugged. Verify that the part number of the new lamp key matches the new UV lamp.
General safety instructions for operating the product.
Specifies required qualifications for installation and operation.
Instructions for safe transport and initial installation of the unit.
Specific safety warnings and precautions for the device.
Describes the intended application of the UV disinfection unit.
Details the water quality and hydraulic conditions required for operation.
Explains the countdown display for UV lamp replacement.
Procedure for replacing an expired UV lamp.
Defines the proper commissioning, operation, and decommissioning of the product.
Details specific inspection activities and their intervals as per EN 806-5.
General| Brand | BWT |
|---|---|
| Model | BEWADES blue 2.0 |
| Category | Water Filtration Systems |
| Language | English |
To Next Page