What to do if BWT Bewades EU Water Filtration Systems UV-Control II displays !LAMP! out error?
If the UV-Control II displays the error message !LAMP! out, the emitter may be defective, the ballast may be faulty, there may be a contact fault in the emitter signal cable or supply network fluctuations. Inspect or replace the emitter, replace the ballasts, and check the emitter signal cable.
How to fix water in the emitter protection tube of BWT Bewades EU?
Water in the emitter protection tube is likely due to condensation forming when the unit is operated without the blue protective cap. Check the installation of the emitter casing tube and seals. Ensure the blue protective cap is correctly positioned and replace the O-ring if necessary.
Why is the emission power low in my BWT Bewades EU Water Filtration Systems?
A low emission power value can be caused by several factors: the UV transmission of the drinking water being too low (water quality not meeting requirements), the water containing iron or manganese that form deposits, emitters that have exceeded their service life, the line running along the emitter being directly in front of the sensor, faulty emitters, sensor malfunction, air bubbles in front of the sensor window, or electromagnetic interference distorting the sensor signal. To resolve this, treat the feed water with filtration, remove deposits on the emitter casing tube and sensor window (replacing the tube if needed), replace the emitter, rotate the emitter slightly, replace the sensor, relieve pressure on the stainless steel radiation chamber and remove and re-install sensor window, o...
Provides essential safety guidelines for product usage.
Specifies the required expertise for installation and operation.
Outlines safe procedures for moving and installing the unit.
Highlights safety measures pertinent to specific product actions.
Covers general regulations, guidelines, and technical specifications for installation.
Guides on the process and safety precautions for replacing UV radiators.
Lists operator checks for water, flow rate, and unit condition.
Details mandatory inspections according to EN 806-5 standards.
Outlines scheduled maintenance activities and wear part replacement.
General| Brand | BWT |
|---|---|
| Model | Bewades EU Series |
| Category | Water Filtration Systems |
| Language | English |
To Next Page