What to do if my BWT Water Filtration System is not supplying softened water?
If your BWT Water Filtration System isn't softening water, first check the regenerative container. If it's empty, refill it. Then, wait about 3 hours for the brine to form. After that, initiate a manual regeneration.
Why is my BWT Water Filtration System not softening water and the flow level is too low?
If your BWT Water Filtration System isn't softening water or the flow is too low, the inlet pressure might be too low. Try increasing the inlet pressure. If needed, install a pressure reducer, and then start a manual regeneration.
Why does my BWT Water Filtration System have coloured rinsing water at start-up?
If you notice coloured rinsing water at the start-up of your BWT Water Filtration System, it's likely due to abrasion particles in the flushing water. To resolve this, simply repeat the start-up rinse.
General| Brand | BWT |
|---|---|
| Model | Bewamat COMB 1 |
| Category | Water Filtration Systems |
| Language | English |
To Next Page