BWT Bewamat COMB 1 - Maintenance in Accordance with en; Replacement of Parts

53
53
EN
9.4 Maintenance in accordance with
EN 806-5
(Carried out by BWT after-sales service or
an authorised technician in accordance with
EN 806-5)
In addition to all inspection activities, maintenance
work on the assemblies listed below is required
every 6 months by BWT after-sales service or a
specialist trained by BWT. A detailed maintenance
manualcanberequestedfromthequaliedtterat
BWT. We recommend that you enter into a mainte-
nance agreement with the BWT after-sales service
departmentoryourtter.
Assembly (the assemblies exist or do not exist
depending on the type and design of a BWT
product)
Cleaning and possibly sanitisation
1.1 Entire hydraulic unit
1.2 End shield
1.3 Gears
1.4 Drive motor
1.5 Control piston
1.6 Red/green injector
1.7 Electrolysis cell
1.8 Locking pin
1.9 Waste water elbow
JG hoses
2.1 Blending
2.2 Water meter cover
2.3 Paddle-wheel
2.4 Guideba󰀪e
2.5 Check valve
2.6 Bypass valve
2.7 Filler plug
3.1 Brine meter
3.2 Brine meter solenoid valve
5.1 Sieve base
5.2 Low salt gauge
5.3 Brine level switch
6.1 AQAStopoorsensor
6.2 AQA test
9.5 Replacement of parts
The operator must ensure that parts that are subject
to wear and ageing during the life of the product are
replacedbyaqualiedtter.
Details of the replacement cycles can be found in
the maintenance manual from BWT.