33
33
EN
1.4 Transport and installation
To avoid damage during transport to the installation
location, do not remove the BWT product from the
packaging until you have reached the relevant
location. Then dispose of the packaging in the
correct manner. Check that the delivery is complete.
If there is a risk of frost, drain all components that
convey water.
Lift or transport the product or its components only
from the designated suspension eyes or attachment
points, if present.
Theproductmustbeinstalledormountedonasu-
cientlystrongandlevelhorizontalsurfaceandmust
be adequately secured against falling or tipping.
1.5 Symbols used
This symbol indicates risks due
to the electrical voltage.
This symbol indicates that this
electrical or electronic device
must not be disposed of in
household waste at the end of
its service life.
This symbol indicates that the
product can be recycled after it
is decommissioned.
This symbol indicates informa-
tion or instructions that you must
observe in order to ensure safe
operation.
1.6 How safety instructions are
displayed
In this document safety instructions precede any
sequence of actions that could cause harm to per-
sonsordamagetoproperty.Allhazardprevention
measures must be followed.
Safety instructions are displayed as follows:
SIGNAL WORD!
Source of hazard
(e.g. electric shock)
Type of hazard (e.g. risk of fatal
injury)!
► Escape or prevent hazard
► Rescue measure (optional)
Signal word / colour Indicates the severi-
tyofthehazard
Warning symbol Calls attention to
thehazard
Source / type of
hazard
Indicates the type
and the source of
thehazard
Consequences of
hazard
Explains the con-
sequences of not
following the safety
instructions
Hazard prevention
measure
Explains how to
avoidthehazard
1.7 Position specications
Allthepositionspecicationsusedinthisdocument
(left,right,front,rear,etc.)arebasedonaviewer
standing in front of the device while looking at the
display.
To Next Page
Loading...
