EasyManua.ls Logo

C-Data FD1204S - 6 Configure Service In OLT Profile Mode; Data Plan

C-Data FD1204S
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Factory Address: Fl1, Bldg B, Wentao Industrial zone, Yingrenshiyongxin Village, Shiyan Street, Baoan district, Shenzhen, Guangdong, China (518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
22
NOTE
Group Name free to enter. WAN Interface select to 3_Other_B_200/epon0.3. Move eth1.0 to
Grouped LAN interface. The purpose of this step is isolate LAN2 from other LAN portavoid
multicast packet flood to other LAN port. If eth1.0(LAN2) move to Grouped LAN interface. LAN2
can only receive multicast traffic. Internet is not work on LAN2. This step is not necessary but
recommended.
Click Advanced Setup Interface Grouping to check interface grouping information.
5.7.5 Configure Gateway ONUHGUVOIP Service--Broadcom Solution
premise condition
OLT connect to uplink device and open multicast service
OLT have created vlan for VOIP
OLT have configured GE port VOIP vlan
OLT have configured PON port VOIP vlan
ONU have registered
1. Configure IPoE WAN in ONU web
Click Advanced SetupWAN Add
Click Next

Table of Contents

Related product manuals