C-Data FD1204S - 3 OLT Upgrade

Company Address: Flat 6, Bldg 4,South 2 of Honghualing Industrial Zone,Liuxian Road, Xili Town, Shenzhen, Guangdong, China(518055)
Factory Address: Fl1, Bldg B, Wentao Industrial zone, Yingrenshiyongxin Village, Shiyan Street, Baoan district, Shenzhen, Guangdong, China (518055)
Tel: +86-755-26014509/4710/4711 Fax:+86-755-26014506
Website: www.cdatatec.com
4
OLT default manage IP (default IP : 192.168.1.100). then input username and password,default
login username is root,password is admin.
Use command as follow can modify the outband management IP:
OLT> enable
OLT# config
OLT(config)# interface mgmt
OLT(config-interface-mgmt)# ip address 192.168.5.100 24
OLT(config-interface-mgmt)# exit
2. Inband management(connect OLT ge port)
First we login olt via console port or mgmt port, and add a vlanif for inband management,
assigned an IP address to this vlan,add the ge port to the vlan,ge port vlan mode can be access or
trunk,which depend on your network environment,then pc connect to OLT ge port（ge1-ge8）
and telnet to the OLT.
The way to set inband mangement ip as follows：
OLT> enable
OLT# config
OLT(config)# vlan 100
OLT(config)# interface ge
OLT(interface-ge)# vlan access 5 100 ----configure ge 5 as inband management port
OLT(interface-ge)# exit
OLT(config)# interface vlanif 100
OLT(interface-vlanif-100)# ip address 192.168.2.100 255.255.255.0
OLT(interface-vlanif-100)# exit
3 OLT Upgrade
1.Set up OLT update topology:
Use a PC as FTP server(run wftpd32.exe or Wftpd.exe in this pc),and connect to OLT mgmt port
or ge port to transmit firmware.