Table of contents
1. Introduction
2. Summary of Warnings
3. Installation
3.1 Location
3.2 Extending and Retracting the Boom
3.3 Fitting the line to the level-wind
3.4 The Line-Limit Tube
Removing and replacing the line-limit tube
3.5 Power Supply
3.6 Network
3.7 Integration into the Survey Network
3.8 Interfacing with Valeport profilers
3.8.1 Configuring Valeport Connect
3.9 Interfacing with AML profilers
3.9.1 Configuring AML Sailfish
3.9.2 Configuring Vigo Depth Relay
4. Getting Started
4.1 Powering the Winch
4.2 Using the IN and OUT Controls
4.3 Accessing and Navigating the Control Software
4.4 Configuring and Attaching the Profiler
4.5 Setting the Data Transfer Position
5. Profiling
5.1 Selecting a different profiler
5.2 Changing the Profiling Mode
5.3 Changing the Recovery Speed
5.4 Setting the Power Budget
5.5 Acquiring a Profile
Using automatic coverage mode
5.6 Repeating a Profile
Repeat Cast on New SWiFT Message
Repeat Cast after ‘x’ minute(s)
Repeat Cast every ‘x’ meters
6. Action if Power Lost
7. Action if the Profiler becomes caught
8. Routine Maintenance
9. Storage and Transport
To Next Page
Loading...