CAB A4+M - Loading Material; Loading Labels or Continuous Media from Roll

12 12
i
Notice!
For adjustments and simple installation work, use the accompanying Allen key located in the upper section
of the print unit. No other tools are required for the work described here.
4.1 Loading Labels or Continuous Media from Roll
4.1.1 Positioning the Media Roll on the Roll Retainer
3
2
4
1
5
4
6
5
3
Fig. 6 Loading media from roll Fig. 7 Margin stop unxed (left) and xed (right)
1. Open cover (13).
2. Turn ring (5) counterclockwise, so that the arrow (6) points to the symbol , and thus release the margin stop
(4).
3. Remove the margin stop (4) from the roll retainer (3).
4. Load label roll (2) on the roll retainer (3) in such a way that the labels can be inserted into the printhead in the
right position. The printing side of the labels must be visible from above.
5. Re-mount the margin stop (4) onto the roll retainer (3). Push the margin stop (4) until both margin stops (1, 4)
touch the label roll (2) and a clear resistance is encountered.
6. Turn ring (5) clockwise, so that the arrow (6) points to the symbol , and thus x the margin stop (4) on the roll
retainer (3).
910 78
13
12
11
910 78
13
12
14
11
15
A4+M A4+T
Fig. 8 Material feed path
4 Loading Material