80 cab Produkttechnik GmbH & Co KG
9. Test Options
Device List
The hardware components installed in the printer and the optional devices
connected to the printer are displayed in this list.
To print the device list, load media (labels, continuous paper) and a transfer
ribbon, which extends over the entire print width of the printer.
The device list will print continuously without sensing the label gap.
1. Switch from "Online" mode to the Offline Menu by pressing the key.
2. Press the key or the key until the "Test" menu is displayed.
Press the key to confirm the selection.
3. Select the "Device list" option by pressing the key or the key and
confirm the selection by pressing the key.
4. Start the printout by pressing the key.
5. The "Device list" is printed using the heat level and print speed set in the
"Setup" menu.
6. To cancel the "Device list" printing, press the key.
7. After completing the printout, the printer will return to the selection list on
the "Test" menu.
Fig. 9n Device List
To Next Page
Loading...
Need help?
General
