97cab Produkttechnik GmbH & Co KG
10. Memory Cards
8. The data that was read from the source card will now be transferred onto
the destination card. As this is happening the progress bar on the LCD
will be emptied.
If not all files were read from the source card yet; the request "Insert
source" will appear on the LCD.
9. Remove the destination card and insert the source card again. The next
cycle of copying will start.
10. Repeat steps 6 to 9 until all the files are copied. When the printer finishes
copying the files the LCD will display "OK ".
11. Press the key to return to the "Memory card" menu selection list.
When the destination card cannot store any more information the LCD will
display "Card full".
To Next Page
Loading...
Need help?
General
