CAB e4 Series - Adjusting the Position of Media Sensor

cab Produkttechnik GmbH & Co KG
17
PRODUCT MARKING AND BARCODE IDENTIFICATION
17
Adjusting the Position of Media Sensor
1. Lift the top cover.
2. Push the Release Lever to release the Printhead Module.
3. Lift the Printhead Module to expose the media sensor cover. (Figure 7-1).
4. Remove the media sensor cover and slide the media sensor to the correct position (refer to Figure
7-3, Figure 7-4 and Figure 7-5).
5. Replace the media sensor cover.
Media sensor cover
Figure 7-1