cab Produkttechnik GmbH & Co KG
9
PRODUCT MARKING AND BARCODE IDENTIFICATION
9
Interface Connection
CAUTION: Make sure the printer is switched OFF before connecting
the interface cable.
The interface between the printer and the host will use either a serial,parallel , USB cable or for Ethernet
connection options.
1. The printer identifies the communication port automatically.
2. The default values of printer port can be obtained from the self-test
report. (See Chapter 2 Operation Basics - System Mode - Self Test)
3. Cable configurations for serial (RS-232C) and parallel
(Centronics) interfaces are shown in Appendix A of this manual.
4. Please take the following measures to reduce cable noise.
a. Reduce the length of the interface cable (keep the cable length
under 1.83 meters / 6 feet) if required.
b. Keep the communication cable separate from power cords.
To Next Page
Loading...
