CAB e4 Series - DIP Switch at the Back Panel

cab Produkttechnik GmbH & Co KG
23
PRODUCT MARKING AND BARCODE IDENTIFICATION
23
DIP Switch at the Back Panel
Caution: Make sure the printer is powered OFF before adjusting
the DIP switch settings.
DIP Bit Functions Remarks
1 ON: Direct thermal print Printing type settings
OFF: Thermal transfer print Default: OFF
2 ON: Enable Back feed Back feed settings
OFF: Disable Back feed Default: OFF
3 ON: Cutter is installed Cutter settings
OFF: Cutter is not installed Default: OFF
4 ON: Peeler is installed Peeler settings
OFF: Peeler is not installed Default: OFF
5 Reserved /
6 Reserved /
8 | 7
RS232 Serial Port
7 0 | 0 – 9600,n,8,1 baud rate setting
0 | 1 – 19200,n,8,1 0: OFF, 1: ON
8 1 | 0 – 38400,n,8,1 Default: 00
1 | 1 – 57600,n,8,1