CAB eos 4 - Page 13

12
13
4 Conguration
Parameter Meaning Default
Cleaning
interval
Setting of intervals for printhead cleaning in increments of 100 m
media passage.
If the set length of the medium (label strip, transfer ribbon) has
passed the printhead and an error occurs in the ow of the medium
(e.g. label end, transfer ribbon end), the Clean printhead!
message appears in the display.
The error message for the error which occurred is not displayed until
the Clean printhead! message is acknowledged. As long as no
errors occur in the medium ow, no messages are displayed and the
print job is continued even if the cleaning interval has passed.
1000 m
Debug mode
Operating mode which supports the rmware programmer when
localizing errors.
Off
Table 4 Parameters of the menu Setup > Machine param.