167 . . .
–
Section 1
7. To exit programming mode,
simultaneously press and
release all three universal
transmitter buttons.
The indicator lights should
turn on.
8. Choose which of the three
buttons you want to program.
9. Press and hold the desired
universal transmitter button
until the device moves.
The indicator light should
begin to blink slowly.
It may take up to 55 seconds
before you see movement.
10. Release the button when the
device moves.
The indicator light will blink
rapidly until programming is
complete.
11. Press and release the
programmed button.
The device should move to
confirm that programming is
successful.
If additional buttons are to be
programmed, repeat the previous
steps.
ROLLING CODE TRANSMITTERS
Read through all of the following
programming procedure before
you begin customizing this
feature.
1. Press and hold the two
outside buttons for about
two seconds, then release
them.
$10araEscaladeEXT Page 167 Wednesday, October 14, 2009 9:54 AM
To Next Page