381 . . .
–
–
–
–
–
Section 5
Insert the hoist end (open end) of
the extension into the hole in the
bumper. Connect the extension
onto the hoist shaft.
Do not use the chisel end of the
wheel wrench.
Turn the wheel wrench counter-
clockwise to lower the spare tire.
Keep turning the wheel wrench
until the spare tire can be pulled
out from under the vehicle.
Use the hook on the wheel wrench
to pull the hoist cable towards you
so that you can reach the spare
tire.
If the spare tire does not lower to
the ground, the secondary latch is
engaged. See "Secondary Latch
System" later in this section for the
proper release procedure.
$10araEscaladeEXT Page 381 Wednesday, October 14, 2009 9:54 AM
To Next Page