Cafe CGY366P4TW2 - Design Information; Product Dimensions and Clearances

4 31-2000814 Rev. 2
Design Information
PRODUCT DIMENSIONS AND CLEARANCES
´
0D[
´0LQ
´0LQLPXP
to Adjacent Wall
Non-
Combustible
Material **
´0LQLPXP
to Combustibles
´0LQLPXP
´
Min.
´0LQ ´0LQ
Island
Cutout
7RS9LHZ
´0LQ
WARNING
,QVWDOODWLRQVZLWKRXWD
KRRGUHTXLUH´PLQLPXPWRFRPEXVWLEOHV
$FXVWRPKRRGLQVWDOODWLRQZLWKH[SRVHG
horizontal combustible surfaces must have
an Auto-On feature. Refer to hood installation
instructions for specific hood clearances.
7KHVXUIDFHRIWKHHQWLUHEDFNZDOODERYH
WKHUDQJHDQGEHORZWKHKRRGPXVWEH
FRYHUHGZLWKDQRQFRPEXVWLEOHPDWHULDO
VXFKDVPHWDOFHUDPLFWLOHEULFNPDUEOHRU
other stone.
CAUTION
To prevent drafts from
DIIHFWLQJEXUQHURSHUDWLRQVHDODOORSHQLQJV
in floor under appliance and behind
DSSOLDQFHZDOO
** As defined in the National Fuel Gas Code (ANSI
=&6$%&XUUHQW(GLWLRQ&OHDUDQFHV
from non-combustible materials are not part of the
$16,=&6$VFRSHDQGDUHQRWFHUWLILHGE\
&6$&OHDUDQFHVOHVVWKDQ´PXVWEHDSSURYHGE\
ORFDOFRGHVDQGRUWKHDXWKRULW\KDYLQJMXULVGLFWLRQ
ADDITIONAL CLEARANCES:
$OORZ´PLQLPXPFOHDUDQFHWRDQDGMDFHQWZDOORQ
each side.
Working areas adjacent to the rangetop should have
´PLQLPXPFOHDUDQFHEHWZHHQFRXQWHUWRSDQGWKH
ERWWRPRIWKHZDOOFDELQHW
)RULVODQGLQVWDOODWLRQPDLQWDLQLQPLQLPXPIURP
cutout to back edge of countertop and 3 in. minimum
IURPFXWRXWWRVLGHHGJHVRIFRXQWHUWRSVHHWRSYLHZ
´
Minimum
Each Side
Back
´
´
´ ´
*DV
Electric
´
´
´
Universal Utility Locations
´
Width
´
Countertop
to Cooking
Surface
´WR´
Height to trim.
Trim to be flush
or higher than
countertop.
´'HSWKWR
Front of Bullnose
´'HSWK
to Front of Door
7RHNLFN
leg Height
´
WR´