Cake Aik - Riding Your CAKE Bike

13
3. Getting started
3.1 Unboxing the vehicle
The delivery from CAKE includes:
• 1x Preassembled CAKE Åik, pedals and handlebar need to be assembled,
see unboxing guide Link here
• 1x Charger
• Reflectors
• 2pcs orange reflector for wheel
• 1 pcs white reflector for front
• 1 pcs red reflector for rear
• 1x Toolset
• 2x Key to the battery lock
• 2x Grey key card for activating the vehicle
• 1x White master key card: required to reprogram a new gray key card if
one is lost.
NOTICE Do not keep the white master key with the vehicle. Keep it safe.
Once unpacked, recycle packaging in accordance with local laws and
regulations.
3.2 Preparing for use
WARNING! When charging, always first connect the charger to the
battery. Thereafter, connect the charger to the mains supply.
• Mount the handlebar and adjust the handlebar angle to optimize rider
comfort, see unboxing guide Link here
• Mount the pedals, see unboxing guide Link here
• Pump the brake levers three times and make sure that they function properly
• Charge the battery to 100 %, i.e, until the battery is fully charged, see
indicators on battery (Due to shipping regulations, the battery state of
charge is low during transport.)
• Add reflectors, see unboxing guide Link here
• Remove the protective film from the display.
• Read the safety instructions.
• Adjust the seatpost, see unboxing guide Link here
• Activate alarm, see 3.4