Cake Aik - Operating and Maintaining Your CAKE Bike; Battery and Charger Handling

25
A. Speedometer unit - The speedometer unit, in Fig. 9, is factory preset,
depending on in which country the vehicle is sold. Possible to change it in
the Cake app.
B. Clock - The clock on the display, in Fig. B, is autonomous and taken from
the bike’s GPS position. If the clock is not correct, please make sure that
your bike is in an area with good GPS signal and let the bike be turned on
for a minimum of 1 hour in order for the bike to adjust the GPS location
and change the time accordingly.
C. Light symbol, the light symbol, in Fig. 9, will show up on display when
turning the light ON via the handlebar light controls. Only valid if you add
the light kit to the bike.
D. Turn signal, the turn signal, in Fig 9, will blink on the display when
activating the turn signal via the handlebar light control. Only valid if you
add the light kit to the bike.
E. SoC - state of charge, 0-100%, If more than 1 battery is connected the
average soc is shown on the display
F. Ride mode - Reach, eciency and power
G. Key card symbol - place your key card on the key card symbol to start
the bike.
H. Error indication - The code is an error code that can be interpreted in the
CAKE app. Most errors indicated by such a code must be solved by CAKE.
6. Operating
6.1 Handling battery and charger

WARNING! Fire hazard. Do not use a damaged battery, as it is highly
flammable. A damaged battery may self-ignite.
NOTICE When the battery is not connected to the vehicle or the charger, the
battery must be stored indoors. Otherwise, humidity may enter through the
inlet and permanently damage the battery.
Pay close attention to how to handle and care for the battery and charger in a
safe way. If the vehicle has not been used for more than 2 weeks, fully charge
the battery before riding. The battery can be charged in the two following
ways: