3. Connect the charger to the mains supply. => The charger light is a steady
red. A red blinking light indicates that something is wrong, see
Troubleshooting
.
4. Wait until the charger light is a steady green. => The battery is fully charged.
3. Disconnect the charger from the mains supply.
4. Unplug the charger from the battery: push the yellow button, then pull the
cable upwards.
5. Plug the battery cable into the battery. The lock mechanism makes a
clicking sound.
Removing the battery
NOTICE When the battery is not connected to the vehicle or the charger, the
battery must be stored indoors. Otherwise, humidity may enter through the
inlet and permanently damage the battery.
See the instruction video on
ridecake.com/en/makka-manuals-and-videos/.
1. Disconnect the battery cable from the battery; push the yellow button,
then pull the cable upwards.
2. Use the key to unlock the battery from the battery holder.
3. Loosen the velcro strap.
4. Carefully remove the battery, or you may cause marks on the frame.
Attaching the battery
1. Place the battery in the battery holder.
2. Fasten the velcro strap over the battery handle.
3. Use the key to lock the battery to the battery holder.
4. Attach the battery cable.
27
To Next Page
Loading...
