• Charge the battery to 100%, i.e., until the charger LED is steady green, see
Charging the battery
. (Due to shipping regulations, the battery state of
charge is low during transport.)
• Check that the handlebar is properly fastened. If needed, adjust the
handlebar angle to optimize rider comfort, see
Adjusting the handlebar angle
.
• Check that the front wheel is properly fastened, see
Checking that the
wheels are fastened
.
• Check that the saddle is properly fastened. If needed, adjust the saddle
angle, depth or height, see
chapter
8.10 Saddle
.
• Mount the side-view mirrors, see
Mounting/adjusting the side-view mirrors
.
• Mount the license plate in accordance with applicable law.
• Stick the reflectors to the side of the rear fender. Mandatory in the US only.
• Remove the protective film from the display.
• Read the safety instructions.
• Get to know the controls.
• Ensure the vehicle is registered and insured in accordance with applicable laws.
4.3 Powering on
1. Plug the battery cable into the battery, see Fig. 3. The lock mechanism
makes a clicking sound.
Fig. 3
Battery cable entry on the battery
15
To Next Page
Loading...
