Cake Makka Range - Work on the Vehicle and Accessories; Tools, Materials, and Substances

8.2 Brake system
Checking that the brake disc screws are tightened, front and rear
Tool: Torx 30.
1. On the front wheel (A), check that the 4 screws are tightened to 17Nm.
2. On the rear wheel (B), check that the 4 screws are tightened to 17 Nm.
Checking that the brake fluid is not too low
Material: Brake fluid DOT3 or DOT4
Wanted state: See Fig 14. When squeezing the brakes, there should be resistance.
1. Check that the air bubble is no bigger than in Fig 14.
2. A bigger air bubble than indicated in Fig 14 means that there is a brake
system leakage somewhere, see Checking the brake hoses for damages.
Fig. 13
Brake disc screws, front and rear
Fig. 14
Correct brake fluid level
33
A
B