Q-
Change Sign (+/-) — Toggle
displayed value between negative
and positive value.
Q+
Pi — Displays the value of
π
(3.1415927).
Q>
x
2
—
Squares a linear or non-
dimensional value.
Q.
Total Cost —
Based on entry of per
unit cost.
Q0
Store Weight per Volume —
Stores a new Weight per Volume
value as listed below:
Note: After entering a value and
pressing
Q0
, continue pressing
the
0
digit key until you’ve reached the
desired Weight per Volume format. To
recall your setting, press
L0
.
• Ton Per CU YD
• LB Per CU YD
• LB Per CU FEET
• MET Ton Per CU M
• kG Per CU M
This value is stored until you change
it or perform a Clear All (
Qx
).
Q5
On-center Spacing (o.c.) —
Stores
a new On-center spacing (e.g.,
400MQ5
). The value is
used for jack and rake wall stud
calculations. Default is 16".
To Next Page
Loading...
