Calculated Industries Construction Master 5 4050 - Entering Square and Cubic Dimensions

Pocket RefeRence Guide — 12
Entering Square/Cubic Dimensions
Examples of entering Square and Cubic
Dimensions:
KEYSTROKE DISPLAY
oo 0.
Enter numeric value and press desired unit
key once to label value as “Linear:”
KEYSTROKE DISPLAY
oo 0.
100M 100 MM
Enter numeric value and press desired unit
key twice to label value as “Square:”
KEYSTROKE DISPLAY
oo 0.
100MM 100 SQ MM
Enter numeric value and press desired unit
key three times to label value as “Cubic:”
KEYSTROKE DISPLAY
oo 0.
100MMM 100 CU MM
Note: If you pass the desired dimensional format,
keep on pressing the dimensional unit key until the
desired result is displayed again.
PRG4050E-A.indd 11
5/24/2013 2:14:07 PM