Calculated Industries Dimension Master Plus - Performing Measurements; Aim Assist Pointer and Measurement Execution

8VHU·V *XLGH ³ 
2. Press the “
Measure
” button (the blue button
on top of the unit) down halfway to activate
the Aim Assist
™
pointer lamp.
Note:
The Aim Assist
™
pointer lamp’s beam
is visible for 35 to 40 ft. If you are measur-
ing in a brightly lit area, the beam may not
be visible. Even so, the narrow beam en-
sures an accurate measurement.
3. Press the “
Measure
” button down com-
pletely to take your measurement.
4. The word “
Run
” displays while the Dimen-
sion Master Plus is measuring. When the
distance has been calculated, a single beep
sounds and the measurement value appears
on the display.
Note:
If the Dimension Master Plus is un-
able to measure the distance, either the word
“none” or “Error” (depending on the
measurement situation) will appear on the
display. Two audible beeps will then sound
alerting you to a measurement problem.