Calculated Industries Dimension Master Plus - Key Functions (Continued); Area and Unit Input Keys

 ³'
,0(16,21
0
$67(5
3
/86

[Sq]
Square Key — Used with a dimension key (feet,
inches, yards, meters) to label entry as an area or
“square” value (e.g., 10 Square Feet).
[ / ]
Fraction Bar Key — Used to separate the nu-
merator and denominator when entering frac-
tions. [Rcl] [/] shows current fraction setting
(Default is 1/8”).
[Length]
Length Key — Labels, stores or recalls a dimen-
sioned value or measurement as Length. Enter-
ing a non-dimensioned value can result in an er-
ror when computing Areas or Widths.
[Width]
Width Key — Labels, stores or recalls a dimen-
sioned value or measurement as Width. Entering
a non-dimensioned value can result in an error
when computing Areas or Widths.
[Height]
Height Key — Labels, stores or recalls a dimen-
sioned value or measurement as Height. Enter-
ing a non-dimensioned value can result in an er-
ror when computing Areas or Widths.
[LxW]
Area Key — Calculates or recalls area based on
Length and Width. If one of these values is not
entered, “None” displays. Repeated presses tog-
gle through the available units of measure.