Adjusting the Wheel
The Celcon
®
polymer wheel can be adjusted
for each user’s preference. To adjust the
wheel, take a small, flat-head jeweler’s
screwdriver and slightly rotate the screw
located near the wheel tip. Rotating the
screw about 1/4 to 1/3 turn should be
sufficient. Rotating the screw within those
two values should adjust the wheel between
free spinning (which is too loose) to skidding
(which is too tight).
9 – Scale Master
®
Pro XE
USING THE SCALE MASTER PRO XE
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
