6) Press [M+] (S) to increase or [RCL] (T)
to decrease the selected digit. Press the
[W/LxW] (X) key to move to the next
digit to the right or the [L] (W) key to
move back to the left.
7) Once the desired value has been entered,
press
[SET] to store value and exit the
programming mode.
Note:
Pressing [ON/CLEAR] will exit the
programming mode without saving any value as
the Custom Scale.
Entering a Custom Scale
1) Press [MODE] until # OPEN (# being
a number 1-5) appears in the scale box
display.
2) Press
[SET] [SCALE]. “ROLL” will appear
in the main display.
3) Press
[SCALE] again. The annunciator
will begin flashing “FT IN” for Imperial
Mode. The left-most digit flashes for
Metric Mode.
Note:
If in Metric Mode, skip to Step 5.
(cont’d)
22 – User’s Guide
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
