(cont’d)
4) To change the units of measurement,
press [UNITS] until your desired units
appear. Press the [W/LxW] (X) or the
[L] (W) key to begin setting the distance.
The selected digit will start flashing.
5) In Imperial mode, the scale will be one
inch equals the distance you entered. In
Metric mode, entered scales are direct
ratios.
6) Press
[M+] (S) to increase or [RCL] (T)
to decrease the selected digit. Press the
[W/LxW] (X) key to move to the next
digit to the right or the [L] (W) key to
move back to the left.
7) Once the desired value has been entered,
press
[SET] to store value and exit the
programming mode.
Press
[RCL] [SCALE] while in custom
mode to display the current custom
scale.
23 – Scale Master
®
Pro XE
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
