CALIENT S Series Getting Started Guide

S320 OCS Getting Started Guide
Doc. Part No. 460166-00
June 29, 2015
Rev. D10
41 of 42
3. Click the Open button to start the SSH session.
If this is your first time connecting to the switch from this computer, you will see the
following message displayed. Accept the connection by clicking the Yes button.
Once the SSH Connection is open, you should see a terminal prompt asking for your
username. The SSH login username for the S320 OCS is tl1user.
4. Enter tl1user.
You are now logged in to your switch with SSH and can begin entering commands at the
prompt. You should see output like this:
agent>
5. Enter the TL1 command act-user to log in to the switch.
The default TL1 username and password are admin and pxc***, respectively.
4.1.3 Connecting Using the Serial Port
Unlike the Telnet connection, TL1 service over the serial port is always enabled. To use the
serial port on the S320 OCS, you will need to connect a serial cable to it; section 3.2.1 provides
step-by-step instructions on how to do this.
Once connected, you can interact with the TL1 Agent through the console or a PC using a
standard terminal emulation program. Table 3 lists the terminal emulation settings for the S320
OCS.

CALIENT S Series Specifications

General

Brand	CALIENT
Model	S Series
Category	Switch
Language	English