Cambium Networks Force 4600C Quick Start Guide

System Hardware 21
System Hardware
This chapter describes the hardware components of an ePMP link.
The following topics are described in this chapter:
l
The Force 4600C hardware, part numbers, mounting equipment, and specifications are described
in Force 4600C.
l
The power supply hardware, part numbers, and specifications are described in Power supply.
l
Cable standards and lengths are described in Ethernet cabling.
l
Surge suppression requirements and recommendations are described in Surge suppression unit.
l
GPS synchronization generation information are described in cnPulse sync generator.
Force 4600C
For details of the Force 4600C hardware, see:
l
Integrated description
l
Part numbers
l
Interfaces
l
Specifications
l
Heater
l
Wind loading
l
Installation
l
Software packages
Integrated description
The Force 4600 series of Subscriber Modules (SM) meets this demand offering high performance and
low latency across both PMP and PTP deployments. The MPE distance for FCC is 371 cm (Dish), 132 cm
(Sector), and for IC is 20 cm.
Force 4600C is shown in Figure 5.

Cambium Networks Force 4600C Specifications

General

Brand	Cambium Networks
Model	Force 4600C
Category	Network Hardware
Language	English