Cambium Networks Force 4600C Quick Start Guide

Regulatory Information 35
Regulatory Information
This section describes planning of the ePMP links to conform to the regulatory restrictions that apply in
the country of operation.
Attention
The user must ensure the ePMP product operates in accordance with local
regulatory limits.
Note
Contact the applicable radio regulator to check if the registration of the ePMP
link is required.
General wireless specifications
The wireless specifications that apply to ePMP 802.11ax variants are listed under Table 20. The wireless
specifications that are specific to each frequency variant are listed in Table 21.
Table 20: Wireless specifications (all variants)
Item Specification
Channel selection Manual selection (fixed frequency)
Automatic Channel Selection
Manual power
control
To avoid interference with other users of the band, maximum power can be set
lower than the default power limit.
Maximum
transmit power
0 to +31 dBm (combined, to regional EIRP limit)
Duplex scheme Adaptive TDD
Over-the-air
encryption
AES
Error Correction FEC
Table 21: Wireless specifications, 6 GHz band
Item 6 GHz
RF band (GHz) 5725 - 7125 MHz
Channel bandwidth 20 MHz, 40 MHz, 80 MHz, or 160 MHz
Typical antenna gain Sector antenna – 18 dBi
Antenna 3 dB Beamwidth Sector antenna: 65° azimuth, 5° elevation

Cambium Networks Force 4600C Specifications

General

Brand	Cambium Networks
Model	Force 4600C
Category	Network Hardware
Language	English