Cambium Networks PTP 850E User Manual

Chapter 7: Quality of Service (QoS) Configuring Egress Shaping
phn-3963_008v000
Page 7-29
Configuring Egress Shaping
This section includes:
• Egress Shaping Overview
• Configuring Queue Shaper Profiles
• Assigning a Queue Shaper Profile to a Queue
Egress Shaping Overview
Egress shaping determines the traffic profile for each queue. PTP 850E can perform queue shaping on the queue
level, using dual leaky bucket shaping. On the queue level, you can configure up to 31 single leaky bucket shaper
profiles. If no profile is attached to the queue, no egress shaping is performed on that queue.
Configuring Queue Shaper Profiles
This section includes:
• Adding a Queue Shaper Profile
• Editing a Queue Shaper Profile
• Deleting a Queue Shaper Profile
Adding a Queue Shaper Profile
To add a queue shaper profile:
1. Select Ethernet > QoS > Shaper > Queue Profiles. The Queue Shaper Profile page opens.

Cambium Networks PTP 850E Specifications

General

Brand	Cambium Networks
Model	PTP 850E
Category	Network Hardware
Language	English