Chapter 13: Unit Management (CLI) Upgrading the Software (CLI)
phn-3963_008v000
Page 13-35
Parameter Input Type Permitted Values Description
directory Text String. The directory path from which you are
downloading the files. Enter the path
relative to the FTP user's home
directory, not the absolute path. To
leave the path blank, enter //. If the
location is the home directory, it
should be left empty. If the location is
a sub-folder under the home directory,
specify the folder name. If the shared
folder is "C:\", this parameter can be
left empty or populated with "//".
server-
username
Text String.
The user name you configured in the
FTP server.
server-
password
Text String. The password you configured in the
FTP server. If you did not configure a
password for your FTP user, simply
omit this parameter.
The following command configures a download from IP address 192.168.1.242, in the directory “current”, with
user name “anonymous” and password “12345.”
root> platform software download channel server set server-
ip 192.168.1.242 directory \current username anonymous password 12345
Downloading a Software Package (CLI)
To initiate a software download, enter the following command in root view:
root> platform software download version protocol ftp
The following prompt appears:
You are about to perform a software management operation. This may cause
a system reset.
Are you sure? (yes/no)
Enter Yes at the prompt. When the prompt appears again, enter the following command to check the download
status:
root> platform software download status show
Once the following message appears, proceed with the installation:
DOWNLOAD VERSION status: download success, process percentage: 100
To Next Page
Loading...
Need help?
General
