Pag. 14 - FA01497M4A - 03/2021 - © CAME S.p.A. -
Saving the user code associated with OUT1 or OUT2
The procedure for saving a user code can be performed from the S0002P card or the keypad
selector
.
For transponder selectors, codes can only be saved from the S0002P card.
The S0002P card can be used to save 50 users or, with the expansion board, 250 users
❺.
From the S0002P card
1
Press the save key ❶
The warning LED will flash slowly.
Changing the installer password
The password can only be changed from the keypad selector.
The installer password is 555 by default. To change the password, please follow the procedure
below.
1
Use the keypad to enter the installer
password and press the following keys
in sequence: (#), (3), (#)
2
Enter the new installer password (3-8
digits) followed by the (#) key.
3
Confirm the new installer password (3-8
digits) followed by the (#) key.
A long beep will sound from the selector
to confirm.
If an incorrect password is entered,
the selector will emit 10 short beeps.
To interrupt the procedure, press the (*) key and the selector will emit 3 short beeps;
alternatively, wait for 20 seconds.
The installer password cannot be used as a user code.
To Next Page
Loading...
Need help?
General
