What to do if CAME Gate Opener neither opens nor closes?
If your CAME Gate Opener is not opening or closing, start by checking the main power supply. Then, ensure the gear motor isn't stuck by unlocking it. Replace the batteries in the transmitter. If problems persist, it may require professional assistance.
Why CAME OPS Gate Opener opens but does not close?
If your CAME Gate Opener opens but doesn't close, the photocells might be dirty. Clean them and check that they are functioning properly.
General| Power Supply | 230 V AC |
|---|---|
| Motor Voltage | 24 V DC |
| Duty Cycle | 30% |
| Opening Time (90°) | 15 s |
| Protection Rating | IP54 |
| Operating Temperature | -20°C to +55°C |
| Control Options | Radio |
Crucial safety guidelines and warnings for personnel performing the installation process.
Overview of the gate operator's capabilities and its specific applications.
Defines operational limits and provides detailed technical performance data.
Detailed measurements of the operator unit in millimeters.
Illustrates the main components and their typical arrangement during installation.
Lists and identifies all individual components of the gate operator system.
Essential checks to perform before installation and list of required tools/materials.
Specifies required cable types and their minimum cross-sectional areas for connections.
Instructions for installing corrugated tubes for electrical wiring.
Steps for preparing and installing the foundation anchoring plate for the operator.
Detailed steps for mounting, connecting cables, and positioning the gearmotor.
Procedures for securely attaching the rack to the gate and operator.
How to adjust gear meshing for optimal performance and reduced wear.
Final steps for securing the gearmotor after adjustments are made.
Setting the precise opening and closing positions using limit switches.
Overview of control board wiring, power supply, and fuse specifications.
Identification of components on the main control board and associated modules.
Information on power supply requirements and connections for the operator.
Wiring diagrams for essential operational components.
Instructions for connecting signaling devices like flashing lights.
Connecting remote controls, keypads, and other input devices.
Configuration and testing procedures for safety devices like photocells.
Guide to programming operational features using DIP switches and buttons.
Setting stop functions, calibrating gate travel, and configuring inputs.
Configuring safety reopening, obstruction wait, and partial opening settings.
Setting gate operation modes and configuring the automatic closing feature.
Configuring automatic closing after partial stop and obstruction detection.
Activating service tests, encoder, and button-activated maintained action.
Adjusting gate speed and setting pre-flashing warning signals.
Saving trimmer adjustments and programming transmitters for various functions.
Deleting users, resetting parameters, and managing system settings.
Guidance on adjusting A.C.T., SP.SLOw, and SENS. trimmers for optimal performance.
Interpreting the meaning of various LED indicators on the control board.
Steps for securing the operator housing after all electrical connections are made.
Common problems, their causes, and recommended fixes for gate operation.
Guidelines for environmentally responsible dismantling and disposal of the product and packaging.
To Next Page
