Need help?Do you have a question about the CAME OPB001CB and is the answer not in the manual?
General| Model | OPB001CB |
|---|---|
| Category | Gate Opener |
| Power Supply | 230 V AC |
| Operating Temperature | -20°C to +55°C |
| Protection Rating | IP44 |
Crucial safety advice for installers to prevent serious harm and ensure proper operation.
Specifies the intended purpose of the operator for residential and apartment block swing gates.
Details required cable types and minimum thicknesses based on cable length for installation.
Steps for preparing junction boxes and corrugated tubing for incoming connections.
Lists and describes the various components of the control card.
Details the input voltage requirements for the system.
Details connections for keypad selectors and AF cards for remote control.
Shows operator installation for one-leaf gates on left or right.
Shows configurations for two-leaf gates with delayed operators.
Explains photocell connections and safety input configuration (CX).
Explains how to use DIP switches to program functions and interpret LED indicators.
Configures motor type and number of motors using DIP switches.
Configures TOTAL STOP button and performs gate travel self-learning.
Configures reopening, obstruction detection, and control modes (e.g., OPEN-CLOSE-INVERT).
Configures partial opening, encoder exclusion, and timed slow-downs.
Enables and configures automatic gate closing features.
Configures automatic closing after partial opening, pre-flashing, closing thrust, and services test.
Configures button for maintained action (gate stays open/closed while pressed).
Manages users, deletes users, and resets parameters.
Guides self-learning with encoder enabled, disabled, and timed slow-downs.
Details functions of A.C.T., APP./O.T., 2M DELAY, SPEED, SLOW, and SENS trimmers.
Instructions for refitting the operator cover and fastening transmission arm protection.
Specific dimensions and procedures for outer opening brace fastening and stop installation.
Wiring diagram for connecting operators to one-leaf swing gates.
Wiring diagrams for connecting operators and gearmotors to two-leaf swing gates.
Addresses common issues like operator not closing and suggests possible fixes.
To Next Page
