p. 3 - Manual FA01054-EN - 01/2018 - © CAME S.p.A. -
Translation of the original instructions
GENERAL PRECAUTIONS FOR INSTALLERS
⚠ CAUTION! Important safety instructions.
Follow all of these instructions. Improper installation can cause serious bodily
harm.
Before continuing, also read the general precautions for users.
This product must only be used for its specifi cally intended purpose. Any other use is
dangerous. Came S.P.A. is not liable for any damage caused by improper, wrongful and
unreasonable use. • This manual's product is defi ned by machinery directive 2006/42/
CE as "partly-completed machinery". Partly-completed machinery is a set that almost
constitutes a machine, but which, alone, cannot ensure a clearly defi ned application.
Partly-completed machinery is only destined to be incorporated or assembled to other
machinery or other partly-completed machinery or apparatuses to build machinery that
is regulated by Directive 2006/42/CE. The fi nal installation must be compliant with
European directive 2006/42/CE and current European reference standards • Given these
considerations, all procedures stated in this manual must be exclusively performed by
expert, qualifi ed sta . • Laying the cables, installation and testing must follow state-
of-the-art procedures as dictated by regulations Before installing the operator, check
that the gate is in proper mechanical condition, that it is properly balanced and that it
properly closes: if any of these conditions are not met, do not continue before having met
all safety requirements. • The operator cannot be used with gates fi tted with pedestrian
doors, unless its operation can be activated only when the pedestrian door is in safety
position. • Make sure that people cannot bet entrapped between the gate's moving and
fi xed parts due to the gate's movement. • Do not fi t the operator upside down or onto
elements that could yield to its weight. If necessary, add reinforcements to the fastening
points • check that the temperature range appearing on the operator is suited to the
place of installation • Do not install door or gate leaves on tilted surfaces • check that
no lawn watering devices spray the operator with water from the bottom up • Suitably
section o and demarcate the entire installation site to prevent unauthorized persons from
entering the area, especially minors and children. • Use proper protections to prevent
mechanical hazards when people are loitering around the machinery's range of action,
for example avoid fi nger crushing hazards between the drive arm and the mechanical
stops when the door is opening, and so on). • Any residual risks must be indicated clearly
with proper signage a xed in visible areas. All of which must be explained to end users
• A x cautionary signs, such as the door plate, the gate plate, wherever needed and in
plain sight. • All opening controls must be installed at least 1.85 m from the perimeter
of the gate's working area, or where they cannot be reached from outside the gate. • If
the operator is installed lower than 2.5 from the ground or from any other access level, fi t
any protections and signs to prevent hazardous situations. • Make sure that mechanical
stops are already installed • Make sure the operator is installed onto a sturdy surface
that is protected from any collisions • Unless the key-operation is functioning (for e.g.
keypad selector, key-switch selector, transponder selector, and so on), any maintained-
action control devices must be installed at least 1.5 m from the ground and out of reach
from unauthorized users. • The manufacturer declines any liability for using non-original
products; which would result in warranty loss • All switches in maintained
To Next Page
Loading...
