DIP
LED (PRG) Tasto PROG
LED 1
LED 2
TX
2
TX 2
10 2 TX
C
-
+
-
NC
+
-
10 TS 2 C1 CX
DN10
p. 19 - Manual FA01054-EN - 01/2018 - © CAME S.p.A. -
Translation of the original instructions
Photocells safety connection (services test)
At each opening and closing, the card checks whether the photocells
are working. Any anomalies will inhibit all commands.
Enable this function when programming.
FUNCTIONS PROGRAMMING
⚠
Only program functions when the operator is stopped.
When programming is finished, set all Dip-switches to OFF.
You can save up to 25 users.
To check whether a function is enabled or disabled, set the DIP switches in the position
that corresponds to the function and check which of the two LEDs is blinking.
LED 1 - the function is disabled.
LED 2 - the function is enabled.
To Next Page
Loading...
