CAME OPB001CB - INSTALLING AND CONNECTIONS FOR OUTER OPENING; Brace Fastening and Mechanical Stops

C max
310 max
A
B
120 min
27,5
UNI 5931
M8x20
p. 27 - Manual FA01054-EN - 01/2018 - © CAME S.p.A. -
Translation of the original instructions
Fastening the mechanical stops
Release the gearmotor.
When opening.
Entirely open the gate leaf. Fit the stop under the casing, against the transmission arm and fasten it with the bolt.
⚠
Warning! If no end stops are fitted, you must fasten the stops.
Leaf opening arc (°) A B C max
90 140 420 60
110 140 420 60
Fastening the braces and applicative dimensions
Establish where you will fit the gate brace and measure where the gate-post brace will fit. Make sure to respect the quotas
shown in the drawing and table.
INSTALLING AND CONNECTIONS FOR OUTER OPENING
Following, are the only things that change compared to a standard installation: