Pag. 15 - FA01497M4A - 03/2021 - © CAME S.p.A. -
2
Use the keypad selector to enter the
new user code (3-8 digits) followed by
the (#) key, or put the keycard near the
transponder.
Assign a username to the position
number using the table shown in the
figure
.
Use an additional list where necessary.
The warning LED remains on for 1 second.
To save the user code associated with OUT2, please follow the same procedure using
the save key ❷from point 1.
To interrupt the procedure, press the delete all code key ❸ or wait for 20 seconds. The
LED will flash 3 times.
From the keypad selector
1
Enter the installer password and press
the following keys in sequence: (#),
(1), (#).
2
Enter the user code (3-8 digits) followed
by the (#) key.
3
Confirm the user code (3-8 digits)
followed by the (#) key.
Assign a username to the
position number using the table
shown in the figure .
Use an additional list where necessary.
A long beep will sound from the selector
to confirm.
If the code has already been saved or
is incorrect, the selector will emit 10 short
beeps.
To save the user code associated with OUT2, please follow the same procedure using
key (2) from point 1.
To interrupt the procedure, press the (*) key and the selector will emit 3 short beeps;
alternatively, wait for 20 seconds.
To Next Page
Loading...
Need help?
General
