Page 8 - Manual FA01669-EN - 12/2021 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
SECOND FUNCTION
In the DEFAULT confi guration, the , and buttons are used for calling the respective internal receivers. Using the
SECOND FUNCTION, the same buttons can be used to call internal receivers 4, 5 and 6.
To enable the function, pick up the handset and press .
Release the button within 2 seconds.
With the function active, the
, , and
button LEDs will fl ash.
Press the
button again to disable the function manually.
If the function is not disabled manually, it remains active for approximately 10 seconds.
Porter functions
These functions are only available where there is a porter’s desk.
Each function must be correctly set up and confi gured during installation.
Call notification from the porter
Request for call to porter
If the porter wishes to be called back, the LED turns on.
The LED turns o when communication with the
porter starts.
Press the
button to let the porter know that you want to
be called back.
To Next Page
Loading...
Need help?
General
