CAME BPT TA/450 - Integral Proportional Algorithms: Timing; Cycle Duration and ON Time Settings

F
E
G
Page 14 - Manual FB00801-EN - ver. 1 - 07/2017 - © CAME S.p.A. - The contents of this manual are subject to change at any time without prior notice.
The first parameter concerns
the duration of the power-on
cycles G.
Activating and configuring an integral proportional algorithm
This algorithm enables the programmable thermostat to reduce boiler power on cycles as
the ambient temperature approaches the set temperature, thus obtaining a considerable
reduction in consumption, maintaining the ideal level of comfort.
Three preset programs are available, suitable for dierent types of installations (P1, P2
and P3), or there is a completely manual program (P4).
If you have chosen the P4 program, pressing P gives access to the programming of the
individual parameters that make up the P4 program (manual).
Use the
buttons to choose
the desired program from: P1,
P2, P3, P4 F (see graphic and
table L); press P to confirm your
choice and end programming.
When the dierential is not active
(
) B, press P to access
the section in which it is possible
to select one of the integral pro-
portional programs available E.