Need help?Do you have a question about the CAME BPT TH/350 and is the answer not in the manual?
General| Temperature Range | 5°C to 35°C |
|---|---|
| Power Supply | 230V AC |
| Display | LCD |
| Mounting | Wall-mounted |
| Temperature Control Accuracy | ±0.5°C |
| Protection Rating | IP30 |
| Weight | 150 g |
| Type | Thermostat |
| Control Type | Digital |
Read instructions, qualified technicians, disconnect power, intended use, battery handling.
Packaging and device disposal regulations, compliance with directives.
Details of subframes, main body, frame, and fixing screws included in the package.
Introduction to how subframes adapt to various wiring systems.
Pairing subframes with specific wiring system brands like BTICINO, VIMAR, and LEGRAND.
Pairing subframes with GEWISS and BTICINO Matix systems.
Pairing subframes with AVE, VIMAR, and ABB wiring systems.
Pairing subframes with GEWISS, BTICINO, and VIMAR systems.
Pairing subframes with AVE, BTICINO, and VIMAR systems.
Installing the unit in a suitable position and inserting the batteries.
Wiring details including mains, relay contacts, loads, and remote inputs.
Diagrams for connecting remote activation and magnetic contacts.
Final steps to assemble the thermostat after wiring and frame setup.
Explanation of all icons on the display and the functions of the front buttons.
How to access internal buttons and a list of their functions.
Cautionary notes regarding initial button presses and cleaning the device.
Steps to set the clock minutes and hours using the unit buttons.
Setting the current day and finishing the clock setting procedure.
Notes on inactivity, button press behavior, and data saving.
Selecting between Heating, Cooling, Off, and Frost protection modes.
Overview of pre-stored programs for heating and cooling temperature levels.
Explanation of the OFF mode and how to activate Frost protection mode.
Adjusting the minimum tolerated room temperature for frost protection.
Steps to select the day of the week for customising the daily temperature program.
Setting time slots and corresponding temperature bands for the daily program.
How to copy programs to other days or program them individually.
Procedure to finish programming the daily temperature schedule.
Setting a delay for programmed activation times and days.
Configuring the duration of the delay in 15, 30, or 45-minute increments.
Setting the specific temperature values for T1, T2, and T3 bands.
Confirming temperature band values and understanding value limitations.
Steps to activate the Wildcard program for the current day.
How to reserve the Wildcard program for a specific day of the week.
Procedure to cancel a previously reserved Wildcard program.
Temporarily disabling automatic control and switching to manual operation.
Setting a specific temperature for a few hours or days.
Configuring the duration and days for the timed manual program.
Modifying the detected temperature by ±3 °C due to placement.
Adjusting the temperature sensor compensation value.
Enabling the feature that automatically adapts system start time for desired temperature.
Steps to enable or disable the automatic advance feature.
Activating and configuring the differential algorithm for temperature control.
Adjusting the differential value between 0 °C and 0.9 °C.
Selecting preset programs or manual configuration for integral proportional control.
Selecting programs P1-P3 or P4, and setting cycle duration and minimum ON time.
Adjusting the proportional band and understanding system type based on graph/table.
Remotely forcing the unit into manual operation mode.
Remotely activating pre-configured heating or cooling programs.
Adjusting the desired temperature value for remote activation programs.
Configuring the number of hours and days for remote activation programs.
Saving the configured program for remote activation.
Displaying the device's operating time.
Procedures for resetting the device or performing a factory reset.
Instructions and cautions for replacing the device batteries.
Detailed technical specifications of the thermostat.
To Next Page
