D
A
Page 20 - Manual FB01002-EN - ver. 1 - 11/2017 - © CAME S.p.A. - The contents of this manual are subject to change at any time without prior notice.
play confirms the conclusion of the temperature band programming.
In any case, 10 seconds after the last operation, the unit exits the procedure, considering
the data set until that moment as valid.
Replace the unit body.
N.B. The value you can assign to each temperature band is limited by the values of the
band immediately higher and lower.
If, for example, the T3 band is set to 20 °C and the T1 band is set to 16 °C, the value of
the T2 band can vary between 16.1 °C and 19.9 °C. If T2 is set to 21 °C, T3 is automati-
cally moved to 21.1 °C.
Set AUTOMATIC operating mode.
Press the
button A.
The appearance of the
icon
confirms that the program has
been activated.
The program can be custom-
ised (see "Customising the daily
Using the Wildcard program
The device has a WILDCARD program (to be used, for example, during midweek holidays,
vacations etc.), that can be started at any time of the current day and remains active until
24:00, or can be reserved for any of the days of the week.
The factory settings envisage the wildcard program having the same profile as the Sunday
profile (7), but it can be customised.
To activate this program for the current day, proceed as follows:
Pull out the unit body.
Press button P to confirm the
value of the temperature shown
on the display and move on to the
next temperature level D.
Proceed as described to set all the
temperature bands as desired.
The reappearance of the entire
daily program graph on the dis-
To Next Page
Loading...
Need help?
General
