B
C
A
Page 23 - Manual FB01002-EN - ver. 1 - 11/2017 - © CAME S.p.A. - The contents of this manual are subject to change at any time without prior notice.
The program composed in this way is activated immediately and remains active until the
set time runs out. The device then goes back to operating in the mode it was in before
the activation of the timed manual program.
To go back to AUTOMATIC operation before the end of the programmed time, press
.
Press
again and use the
buttons to set the desired activa-
tion days C.
Press
and use the but-
tons to set the desired activation
times B.
Changing the temperature sensor calibration
If the device is in a position that means that it is dicult for it to detect the correct
temperature, it is possible to modify the temperature detected by ± 3 °C in increments
of a tenth of a degree.
Pull out the unit body.
Activate MANUAL operating
mode.
Press button P A.
To Next Page
Loading...
Need help?
General
