G
A
B
Page 18 - Manual FB01002-EN - ver. 1 - 11/2017 - © CAME S.p.A. - The contents of this manual are subject to change at any time without prior notice.
Pull out the unit body.
Set AUTOMATIC operating mode.
Press the 1÷7 button A to select
the day of the week on which to
add the delay.
Press the
0÷23 button B to
select the time on the chosen day
at which to add the delay.
Press
G to end programming.
The procedure will automatically
end after 10 seconds of inactivity.
Adding a delay to a programmed activation
This feature is designed to delay the activation programmed for a specific time.
If, for example, you want a comfort temperature at 07:00, it is possible to make sure that
the system comes on at 06:30. To reach this objective, program the desired temperature
for 06:00 and set a delay of 30 minutes. The device will activate the system at 06:30.
The indication of the added delay is shown on the display during the hour in which the
delay has been programmed.
N.B. The delay time can be programmed for several hours in the same day and for
several days a week.
To Next Page
Loading...
