A
1
2
Page 14 - Manual FA01734-EN - 06/2022 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
5) Place the ½ inch (CCT) chain between the gearmotor and the reset. The length of the chain must be equal to twice distance A.
7) Adjust the chain tension using the reset screw and then lock the nuts.
8) First secure the brackets and the plates to the chain, and then to the door leaves.
6) Join the two ends of the chain using the (CGIU) joint).
To Next Page
Loading...
Need help?
General
