Page 10 - Manual FA 01624 - EN - 03/2022 - © CAME S.p.A. -The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Automatic door-release function
Door status function
The LED next to this button indicates the
current door status.
☞The system must be correctly set up.
☞The function is active during the steps
that involve communicating with the entry
panel and the signal refers to the entrance
associated with the entry panel.
This function allows you to automatically
open the entrance when you press the call
button on the entry panel.
This function is useful for professional
practices.
Press and hold this button for more than
3 seconds to enable/disable the function.
☞The LED switches on to indicate that the
function has been enabled.
☞The call ends automatically.
Open-gate function/status
Press and hold the button for a prolonged
period to send an open/close command to
an operator. The LED indicates the status
of the operator.
☞ The system must be correctly set up
and confi gured.
☞The function must be activated on the
receiver when the call is being associated
during system programming.
To Next Page
Loading...
Need help?
General
